V-Tech DT596F_KP Manual - Manual (Page 13)

-11-
5.DIP Switches Setting
DIP Switches Settings of Monitor
DIP Switches Settings of Door Station
Total•4•bits•on•the•DIP•switches•can•be•configured.The•switches•can•be•modified•either•before•or•after•installation.
Setting Item Bit state Descriptions
Bit1•and•Bit2
(it•is•used•to•set•the•ID•
code•for•door•station)
Default•setting,•ID•=•0(00),•set•to•the•first•Door•Station.
ID•=•1(10),•set•to•the•second•Door•Station.
ID•=•2(01),•set•to•the•third•Door•Station.
ID•=•3(11),•set•to•the•fourth•Door•Station.
Bit3
Activate•alarm•function,•S2+•and•S-•terminals•are•used•to•
connect•alarm.Please•note•that•the•second•lock•can•not•be•
connected•to•the•system•if•activate•alarm•function
Not•activate
Bit4
Reserve
There•are•6•bit•switches•in•total.•The•DIP•switches•are•used•to•configure•the•User•Code•for•each•Monitor.
ON(1)
=
OFF(0)
=
ON ON
Bit-6•is•line•terminal•switch,•which•have•to•be•set•to•ON•if•the•Monitor•is•in•the•end•of•the•bus,•otherwise•set•to•OFF.•
Bit state Setting Bit state Setting
The•monitor•is••
not•at•the•end•
of•the•bus.
The•monitor•
is•at•the•end•
of•the•bus. 1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 34
ON
1 2 34
ON
1 2 34
ON
1 2 34
ON
1 2 3 4
ON
1 2 3 4
ON