V-Tech VT584 Manual - Manual (Page 2)

VT-ENG-584-V2 090S817
8. Specifications:
● Power Supply: DC 10~12V (Powered by Monitors)
● Consumption: 150mA in working state (latch not included)
● Video Output: 75Ohm, 1Vp-p, CCIR standard (unless specified)
● Camera: 76 degree, CCD or CMOS camera with IR-LED
● Working temperature: -10 ~ 40 degree
7. Connect a lock using the Monitor power only
6. Connect an electro-magnetic lock(power-OFF-to-open)
5. Connect an electron lock(power-ON-to-open)
1R 2W 3Y
4B
Connect to Monitor
Remove the JS/LK jumper on Monitor
Red Black +
-
Safety Type: Power-on-to-open
The lock consumption must not
greater than 12V 500mA.
Electronic lock
1R 2W 3Y 4B
3 2 1
VT584
The lock consumption must not
greater than DC 48V 1.5A.
Safety Type: Power-off-to-open
Black
Red
White
Electron-Magnetic lock
Adaptor
+
+
-
-
1R 2W 3Y 4B
1R 2W 3Y
4B
Connect to Monitor
Keep the JS/LK jumper on Monitor
3 2 1
VT584
1R 2W 3Y 4B
1R 2W 3Y
4B
Safety Type: Power-on-to-open
Connect to Monitor
Keep the JS/LK jumper on Monitor
3 2 1
Black Red
White
VT584
Adaptor
+ + -
-
The lock consumption must not
greater than 48V 1.5A.
Electronic lock
1. When using the power solely from the
Monitor, only the Power-on-to-unlock type
electronic lock can be supported. The
rating of the lock must be less than 12V
500mA.
2. Connect the 2 Black wire to the 1 Red
wire from Monitor, connect 1 Red wire to
the lock (+), connect 2 White wire from
Monitor to the lock (-).
1. When connecting an electro-magnetic
lock, an external power supply is needed
(not included with this product).
2. The rating of the lock must be less than
DC 48V 1.5A.
3. Connect the 2 Black wire to the power
(+), connect 3 White wire to lock (+), and
connect the power (-) to the lock (-).
1. When connecting an electric lock, an
external power supply is needed (not
included).
2. The rating of the lock must be less than
DC 48V 1.5A.
3. Connect the 2 Black wire to the power
(+), connect 1 Red wire to lock(+), and
connect the power (-) to the lock (-).