V-Tech AT25_D4 Manual - Manual (Page 8)

Select Alarm Function on main menu
page to enter alarm function page as
shown on the right.
○ Operation instructions：
Alarm Function
Armed-Out
Armed-Stay Home
Disarm
Alarm Status ...
Change Password ...
Exit OK Adjust
1. Select Armed-Out item to trigger
defense function,If the armed function
is activated,the Alarm Status page
will be shown"Status:Armed".
2. If you stay at home, and you want
to activate the defense function, you
should select Armed-Stay Home item
to trigger all defense function except
Infrared defense,If the armed function
is activated,the Alarm Status page will
be shown"Status:Armed".
Alarm Status
Door Magnetic IR
Gas or Smoke Emergency
Alarm 5 Alarm 6
Alarm 7
Status: normal armed
Alarm 8
Exit
3. Out-Delay Period: after you arm the system, you will get into Out Delay Period,
monitor will sent out short “Di” every 3 seconds; you will hear a long “Di~” at
the end of the Out Delay Period, and the system is gotten into the protecting
status. By default, the Out Delay Period is 40 seconds, users must get out off the
room within 40 seconds, otherwise the system will treat the user as a invader and
sent out the alarm signal.
4. In-Delay Period: When the system is armed, the defence alarm are activated,
to disarm the alarms. When you come into the room, you have 40 seconds to
deactivate the sensors(by enter MAIN --> ALARM menu, select Disarm item); if
you didn’t deactivate the sensors after 40 seconds, the monitor will sent out alarm
sound and sent the alarm signal to the Guard Unit.
5. 40 seconds is the default setting for in-out delay time, it can be changed by the
administrator.
- 6 -