Warrior 2960 Complete LED Tail Light Kit (2007 – 2013 Jeep JK Wrangler) User Manual
Warrior For the car
Protecting Your Adventure Lifestyle
========================================================================================
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
JK Complete LED Tail Light Kit
INSTALLATION INSTRUCTIONS
WAR 2960
Installation:
1. Remove both stock tail lights by unscrewing the two screws in the tail light on the inside edge nearest the
tailgate. The outer two do not need to be removed.
2. Remove the two threaded metal inserts that hold the stock tail light in place
3. It is recommended that you use tape around the tail light to protect your vehicle while installing the light
boxes. Blue painters tape works well for this.
4. Hold your tail light box into place and attach to the two inner mounting holes for the taillight using the
supplied 1” long bolts with a washer and nylock nut on the back side.
5. The outer two holes need to be drilled, use a 5/16” drill bit to drill the holes. After they are drilled, remove
the light box.
6. Cut out the rear of the JK tub to allow for clearance for the 4” LED tail light. This is a trial and error fit.
Photo on the right is the finished result.