Vitek VT-1209 - Manual (Page 6)

6
ENGLISH
of fabric), the (9) indicator will light up.
• When the soleplate temperature (13)
reaches the desired temperature value,
the (9) indicator will go out, you can start
ironing.
Note: While steam ironing set the tem-
perature «•••» or «МАХ».
WATER SPRAYER
• You can dampen the fabric by pressing
the spray button (4) several times.
• Make sure that there is enough water in
the water tank (10).
IRONING
• Place the iron on the base (8).
• Insert the power plug into the outlet.
• Set the temperature regulator (11) to the
required ironing temperature: “•”, “••”,
“•••” or “max” (depending on the type
of fabric), the (9) indicator will light up.
• When the soleplate temperature (13)
reaches the desired temperature point,
the (9) indicator will go out, you can start
ironing.
• When you finish ironing set the (11) regu-
lator to the “min” position.
• Pull the plug out of the socket and let the
iron cool down completely.
STEAM IRONING
For steam ironing set the temperature reg-
ulator to «•••» or «МАХ». The iron has an
anti-drop valve, which stops water supply,
when the soleplate temperature is too low
it prevents the appearance of drops out of
the soleplate openings (13). While heat-
ing or cooling down of the soleplate (13),
you will hear clicks of opening/closing of
the anti-drop valve it means that the valve
works normally.
• Place the iron on the base (8).
• Insert the power plug into the outlet.
• Make sure that there is enough water in
the water tank (10).
• Set the temperature regulator (11) to the
required ironing temperature: “•••” or
“max”, the (9) indicator will light up.
• When the soleplate temperature (13)
reaches the desired temperature point,
the (9) indicator will go out, you can start
ironing.
• Turn the steam supply regulator (3) to set
the intensity of steaming, steam will start
outgoing from the openings of the sole-
plate (13).
• When you finish ironing set the (11) regu-
lator to the “min” position and the steam
supply regulator (3) to the left position.
• Pull the plug out of the socket and let the
iron cool down completely.
ATTENTION!
If during the operation steam is not con-
stantly supplied, check whether the tem-
perature regulator (11) is set properly.
ADDITIONAL STEAM RELEASE
Additional steam release function is useful
when ironing folds and can only be used at
high ironing temperatures (when the iron
temperature regulator (11) is set to “•••”
or “max”).
• When the additional steam release but-
ton (5) is pressed, steam will be vigor-
ously released from the openings in the
iron soleplate.
Note: In order to avoid leakage of water
from steam openings, press the addi-
tional steam supply button (5) with 4-5
sec. interval.
AUTO-SWITCH OFF FUNCTION
If the iron is about 30 seconds in the hori-
zontal position or about 8 minutes in the ver-
tical position it will switch off automatically.
To switch on the iron, just start ironing.
Note: After switching on of the iron the
preset temperature of the iron soleplate
VT-1209.indd 6 VT-1209.indd 6 11.08.2009 15:20:05 11.08.2009 15:20:05