2 mounting steps, 3 mounting steps external housing – VEGA VEGABAR 65 Profibus PA User Manual
Page 13
1
2
Fig. 4: Temperature ranges
1
Process temperature
2
Ambient temperature
4
.2 Mounting steps
For mounting VEGABAR 65, a welded socket is required. You can find
these components in the supplementary instructions manual "Welded
socket and seals".
Use the seal corresponding to the instrument:
- or -
Seal with a suitable resistant seal:
l
Flange connection according to DIN/ANSI
à Screw VEGABAR 65 into the welded socket. Tighten the hexagon
screw on the process fitting with SW 27 (spanner width 27 mm).
Warning:
The housing must not be used to screw the instrument in! Applying
tightening force can damage internal parts of the housing.
4
.3 Mounting steps external housing
1
Mark the holes according to the following drilling template
2
Depending on the mounting surface, fasten the wall mounting
plate with 4 screws
Welding the socket
Sealing/Screwing in
Wall mounting
VEGABAR
65 • Profibus PA
13
4 Mounting
28253
-
EN
-090522