VEGA VEGAKON 63 - Manual (Page 11)

VEGAKON 11
4.3 Functional table
The following table shows the switching conditions dependent on the adjusted mode and level.
Level Switching condition Switching condition Signal lamp
Relay module E60 R Transistor module E60 T VEGAKON
Mode A
Relay energized Transistor conductive light off
Maximum
monitoring
or overfill
protection
Relay de-energized Transistor blocks light on
Mode B
Relay energized Transistor conductive light off
Minimum
monitoring
or protection
against dry
running of
pumps
Relay de-energized Transistor blocks light on
Power failure
Mode Relay de-energized Transistor blocks light off
A/B
Note
If VEGAKON is used for oil warning in water, the electrode must be cleaned after responding to oil (empty signal)
as otherwise reset to water is not reliably guaranteed.
Set-up
6 4 5
6 4 5
6 4 5
6 4 5
6 4 5