5 setup – VEGA VEGAMET 514V User Manual
Page 16
Advertising
16
VEGAMET 514V
Setup
5 Setup
• Adjust the VEGAMET instrument address
on the circuit board by means of the rotary
switch (only necessary, if several
VEGAMET are connected by means of
DISBUS).
• Install VEGAMET.
• Connect sensor and power supply.
• After switching on, the display indicates for
approx. 10 secs the instrument type and
the software version, e.g. "MET 514V
V1.12“.
• If a measurement loop has not yet been
configured, the display shows "Configura-
tion“, the red failure LED also lights. In this
case, proceed as described under "7.1
Configuration measurement loop“.
• If a measurement loop has been
configured, the display shows a value, e.g.
"TAG-No. 1 21.8 %“.You can now carry out
the settings as described in chapter "6
Settings in the reduced menu“.
Advertising