VEGA VEGABAR series 50_60 - Manual (Page 8)

8
4 Mounting
Electronics module • VEGABAR series 50/60
30175-EN-130322
The electronics module BR-E.50P. is suitable for all VEGABARs of
series 50 and 60 with signal output Profibus PA.
The electronics module BR-E.50M. is suitable for all VEGABARs of
series 50 and 60 with signal output Profibus PA - climate-compensat-
ed.
The electronics module BR-E.50F.. is suitable for all VEGABARs of
series 50 and 60 - Foundation Fieldbus.
The electronics module BR-E.50N.. is suitable for all VEGABARs of
series 50 and 60 - Foundation Fieldbus - climate-compensated.
4.3 Mounting steps
The electronics module is located in the electronics compartment.
The below illustrations show the respective position of the electronics
compartment in a single or double chamber housing.
1
Fig. 1: Single chamber housing
1 Position of the electronics compartment
1
Fig. 2: Double chamber housing
1 Position of the electronics compartment
Proceed as follows:
1. Switch off power supply
2. Unscrew housing cover of the electronics compartment
3. Disconnect the connection cables according to the operating
instructions manual of the respective sensor
4. Loosen the two holding screws with a screwdriver (Torx size T 10
or Phillips size 4)
Profibus PA
Foundation Fieldbus
Mounting steps