VEGA EL 4 Conductive probe User Manual
Page 14
1
Connect the eyelet according to the following illustration.
Make sure that the eyelets have no contact to other metal parts.
2
Open one of the other terminals and attach the component.
3
Tighten the terminal.
1
2
Fig. 7: Mounting of the component for line break monitoring
1
Connection to terminal 1 (ground rod = longest rod)
2
Connection to terminal 2 (max. rod = shortest rod)
3
Component for line break monitoring with VEGATOR 632
If you are using a probe without component for line break monitoring, a
fault signal will be triggered.
Keep in mind that in case of a fault signal also the switching output will
be activated.
Only failures of channel 1 are monitored.
Take note of the operating instructions manual of the signal
conditioning instrument.
14
Conductive probe EL 4
5 Connecting to power supply
32653
-EN
-100208