3 wiring plan, single chamber housing – VEGA VEGAWAVE 61 - Relay (DPDT) User Manual
Page 16
5
Lift the opening levers of the terminals with a screwdriver (see
following illustration)
Fig. 8: Connection steps 5 and 6
6
Insert the wire ends into the open terminals according to the wiring
plan
7
Press down the opening levers of the terminals, you will hear the
terminal spring closing
8
Check the hold of the wires in the terminals by lightly pulling on
them
9
Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
10 If necessary, carry out a fresh adjustment
11 Screw the housing cover back on
The electrical connection is finished.
5
.3 Wiring plan, single chamber housing
The following illustrations apply to the non-Ex as well as to the EEx-d
version.
16
VEGAWAVE
61 • - Relay (DPDT)
5 Connecting to power supply
32247
-EN
-120418