M-AUDIO DIO2448 - Manual (Page 14)

14
a number of mixes from a DAT into an editing program, performing the
appropriate edits, and transferring the edited material back to DAT.
Transferring From DAT TO DiO 2448
1. Connect the DAT coaxial S/PDIF output to the DiO 2448 coaxial S/PDIF
Input using a good quality digital cable. Since only one S/PDIF input
may be active at a time, leave the DiO 2448 optical S/PDIF input
disconnected.
2. Connect the DiO 2448 analog outputs to some type of amplified sound
system. The sound system should be equipped with speakers or
headphones.
3. Open the DiO 2448 Control Panel software. Within the control panel,
verify that “Monitor SPDIF-IN at ANALOG-OUT” is selected. This
enables you to monitor the incoming S/PDIF audio via your sound
system.
A
UDIO
S/PDIF
OUT IN OUT R L IN
SOUND SYSTEM
DAT
DiO 2448
Coaxial
Out
Coaxial
In
Analog
Out