VEGA VEGADIF 65 Foundation Fieldbus User Manual
Page 35
35
5 Connecting to power supply
VEGADIF 65 • Foundation Fieldbus
36130-EN-130417
Fig. 34: Connection steps 6 and 7
Proceed as follows:
1. Loosen the four screws on the housing base with an Allen key
size 4
2. Remove the mounting plate from the housing socket
3
2
1
Fig. 35: Components of the external housing
1 Screws
2 Wall mounting plate
3 Cable gland
3. Loop the connection cable through the cable entry on the housing
base
1)
IP 68 version with exter-
nal housing
1)
The connection cable comes pre-assembled. If necessary, shorten it to the
requested length, cut the breather capillaries clean. Remove approx. 5 cm of
the cable mantle, strip approx. 1 cm insulation from the ends of the individual
wires. After shortening the cable, fasten the type plate with support back on
the cable.