VEGA VEGADIF 65 Electronics module User Manual
Page 8
Advertising
2
1
Fig. 3: Loosening the holding screws
1
Electronics module
2
Screws (2 pcs.)
5
Pull the previous electronics out by holding the opening levers.
Note:
Make sure that the housing is not rotated during the electronics
exchange. Otherwise the plug may be in a different position later.
6
Insert the new electronics module carefully. Make sure that the
plug is in the correct position.
7
Insert the two hold screws and tighten them
8
Connect the connection cables according to the operating
instructions manual of the respective sensor
9
Screw the housing cover on
The electronics exchange is now finished.
As a rule, the exchange of the electronics must be documented
internally when used in Ex applications.
8
Electronics module • VEGADIF 65
4 Mounting
36132
-EN
-091210
Advertising