3 wiring plan, single chamber housing – VEGA VEGAPULS 62 (≥ 2.0.0 - ≥ 4.0.0) Foundation Fieldbus Approval according to LPR radio standard User Manual
Page 27
9
Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
10 Screw the housing cover back on
The electrical connection is finished.
Information:
The terminal block is pluggable and can be removed from the
electronics. To do this, lift the terminal block with a small screwdriver
and pull it out. When inserting the terminal block again, you should
hear it snap in.
5
.3 Wiring plan, single chamber housing
1
2
( )
(-)
1
5
0
1
0
1
+
6
7
8
Bus
2
3
4
5
Fig. 20: Electronics and connection compartment, single chamber housing
1
Voltage supply, signal output
2
Contact pins for the indicating and adjustment module or interface adapter
3
Simulation switch ("1" = mode for simulation release)
4
For external indicating and adjustment unit
5
Ground terminal for connection of the cable screen
Electronics and connec-
tion compartment
VEGAPULS
62 • Approval according to LPR radio standard
27
5 Connecting to the bus system
41721
-EN
-120301