VEGA VEGAFLEX 83 4 … 20 mA_HART two-wire Rod probe - Polished version With SIL qualification - Manual (Page 28)

28
5 Connecting to power supply
VEGAFLEX 83 • 4 … 20 mA/HART two-wire
44225-EN-130823
1
USB
Status
Test
SIM-Card
1 2 +
( ) (-)
Fig. 24: Radio module PLICSMOBILE integrated in the connection compart-
ment
1 Voltage supply
You can find detailed information on connection in the supplementary
instructions "PLICSMOBILE GSM/GPRS radio module".
5.8 Switch-on phase
After connecting the instrument to power supply or after a voltage
recurrence, the instrument carries out a self-check for approx. 30 s:
•
Internal check of the electronics
•
Indication of the instrument type, hardware and software version,
measurement loop name on the display or PC
•
Indication of the status message "F 105 Determine measured
value" on the display or PC
•
The output signal jumps to the set error current
As soon as a plausible measured value is found, the corresponding
current is outputted to the signal cable. The value corresponds to the
actual level as well as the settings already carried out, e.g. factory
setting.