VEGA VEGAPULS 61 (≥ 2.0.0 - ≥ 4.0.0) Profibus PA Approval according to LPR radio standard - Manual (Page 48)

Caution:
Note the following if the instrument with corresponding approval is
used as part of an overfill protection system according to WHG:
If a linearisation curve is selected, the measuring signal is no longer
compulsorily linear proportional to the level. This must be taken into
consideration by the user, particularly when adjusting the switching
point on the level switch.
When a reset is carried out, all settings (with only a few exceptions) are
reset. The exceptions are: PIN, language, lighting, SIL and HART
mode.
The following reset functions are available:
l Delivery status: Restoring the parameter settings at the time of
shipment from the factory incl. the order-specific settings. A
created false signal suppression, user-programmable linearization
curve, measured value memory as well as event memory will be
deleted.
l Basic settings: Resetting of the parameter settings incl. special
and laboratory parameters to the default values of the respective
instrument. Any created false signal suppression, user program-
mable linearization curve, measured value memory as well as
event memory will be deleted.
l Setup: Resetting of the parameter settings to the default values of
the respective instrument . Order-related settings remain but are
not taken over into the current parameters. User-generated false
signal suppression, user-programmed linearization curve, meas-
ured value memory, echo curve memory as well as event memory
remain untouched. The linearization is set to linear.
l False signal suppression: Deleting a previously created false
signal suppression. The false signal suppression created in the
factory remains active.
l Peak values measured value: Resetting of the measured min.
and max. distances to the actual measured value.
Select the requested reset function [->] and confirm with [OK].
The following table shows the default values of VEGAPULS 61:
Additional settings/Re-
set
48 VEGAPULS 61 • Approval according to LPR radio standard
6 Set up with the indicating and adjustment module
41715
-EN
-120301