Altronix Maximal7 Installation Instructions - Manual (Page 14)

- 14 - Maximal3/Maximal5/Maximal7 Access Power Controllers (Fused)
CUT
JUMPER J3
FROM FACP
SIGNAL OUTPUT
CIRCUIT
+
--
FACP
SIGNAL CIRCUIT
OUTPUT EOL
NO C NC
FACP INTERF
ACE
JUMPER
N.C. DRY
TRIGGER
INPUT
NO C NC
FACP INTERF
ACE
N.C. TRIGGER
INPUT
N.C. RESET
SWITCH
JUMPER
N.O. TRIGGER
INPUT
NO C NC
FACP INTERF
ACE
N.C.
RESET
SWITCH
N.O.
TRIGGER
INPUT
JUMPER
NO C NC
FACP Hook-up Diagrams:
Fig. 9 Normally Open - Non-Latching FACP
trigger input:
Fig. 10 Normally Open FACP Latching trigger input
with reset:
(This output has not been evaluated by UL)
Fig. 11 Normally Closed - Non-Latching FACP
trigger input:
Fig. 12 Normally Closed - Latching FACP trigger input
with reset:
(This output has not been evaluated by UL)
Fig. 8 Polarity reversal input from FACP signaling circuit
output (polarity is referenced in alarm condition):