Altronix 6030 Installation Instructions User Manual

6030 - multi-purpose timer, Overview, Installation instructions

Advertising
background image

6030 - Multi-Purpose Timer

Overview:

The 6030 programmable timer is suitable for most functions that require a timed operation e.g. Applications, Siren/Bell
Cut Off Module, Dialer Delay, Guard Tour Supervisory Timer, Pulser / Flasher, etc.

Specifications:

• 6VDC or 12VDC operation is selectable.
• Quick and extremely accurate time range adjustment from 1 second to 60 minutes.
• LED indicates relay is energized.
• Form "C" relay contacts are 5 amp at 120VAC/28VDC.
• Current draw stand by 3mA relay energizes at 75mA.
• Repeat (flasher/pulse) mode.
• Relay activates at the end of the timing cycle
Board Dimensions: 3"L x 2.5"W x .75"H

Installation Instructions:

1. Select operation 6VDC (closed) or 12VDC (open) using clip switch marked [SW1].
2. Timing begins when power is applied.
3. Relay energizes at the end of timing cycle.
4. Desired setting is easily and accurately obtained by alignment of arrow on

the potentiometer marked (top right hand corner) on the board.

5. Two timing ranges, 1-60 seconds or 1-60 minutes is selectable with clip switch marked [SW2]

(Open for minutes / Closed for seconds).

6. Latched (ON) LED indicates that timing cycle has ended and relay is energized.
7. Board resets when power is removed or can be reset with the application of momentary closure from terminal

marked [+] to terminal marked [TRG].

8. Cutting the repeat jumper (zero ohm resistor located immediately to the right of the

potentiometer) will cause the relay to cycle on and off at equal intervals. The timer will be
in the pulser / flasher mode of operation.

T

R

G

--

-

+

N

O

C

N

C

BELL

OUTPUT

+

--

DIALER OR

TRANSMITTER

+

--

T

R

G

--

-

+

N

O

C

N

C

BELL

OUTPUT

+

--

+

--

CONTROL PANEL

BELL

OR

SIREN

Wiring Diagram for Delayed

Dialer/Transmitter or Local Alarm:

Wiring Diagram for

Bell or Siren Cut Off:

Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.

140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056
website: www.altronix.com, e-mail: [email protected], Lifetime Warranty, Made in U.S.A.
II6030 - Rev. 081205

H04F

MEMBER

TRG

---

+

NO

C

NC

CLOSED - 6V

OPEN - 12V

OPEN - MIN

CLOSED - SEC

SW1

SW2

15

45

60

1

Advertising