ViTESSE VS-662 - Manual (Page 3)

Colorfull Water tank
Water tank can change the color against the different soleplate
temperature .There are five different water tank:Setting “0” blue setting 1
green
setting 2 orange III setting purple MAX setting red.[Fig.7]
Renewable anti-calc system
A special resin filter inside the water reservoir softens the water and prevents
scale build-up in the plate. The anti-calc system can be changable
clockwise
the anti-calc box out by using the icon or similar equipment,and couterwise the
anti-calc box in by using the icon or similar equipment too.
[Fig. 9]
Please note:
Use tap water only. Distilled and/demineralised water makes the anti-calc
system ineffective by altering its physicochemical characteristics.
Do not use chemical additives, scented substances or decalcifiers. Failure
to comply with the above-mentioned regulations leads to the loss of
guarantee.
Anti-drip system
With the anti-drip system, you can perfectly iron even the most delicate
fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to
the point where no more steam comes out, but rather drops of boiling
water that can leave marks or stains. In these cases, the Anti-drip system
automatically activates to prevent vaporization, so that you can iron the
most delicate fabrics without risk of spoiling or staining them.
Automatic shut off
The automatic shut off device trips after the iron has been left for approx.
eight minutes in the upright position or unused for approx. Thirty seconds in
the horizontal position. The light comes on to indicate that shut off has
tripped. As soon as you move the iron, the device turns off and the iron
starts working again.
General Instructions
When using the iron for the first time, you may notice a slight emission of
smoke and hear some sounds made by the expanding plastics. This is quite
normal and it stops after a short time. We also recommend passing the
iron over an ordinary cloth before using it for the first time.
GARMENT
LABEL
FABRIC
TYPE
THERMOSTAT
REGULATION
synthetic
silk - wool
Cotton - linen
•
low temperature
••
medium temperature
Fabric not to be ironed
•••
high temperature
Preparations
Soft the laundry to be ironed according to the international symbols on the
garment label, or if this is missing, according to the type of fabric.
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to
cool down) and eliminates the risk of scorching the fabric.
Steam ironing
Filling the reservoir
1.
Check that the plug is disconnected from the socket.
2. Move the steam selector H to “ ” [Fig. 5].
3. Open the lid B.
4. Raise the tip of the iron to help the water enter the opening without
overflowing [Fig. 1].
5. Slowly pour the water into the reservoir using the special measure M
and taking care not to go over the maximum level (about 400ml)
indicated by “MAX” on the reservoir.
6. Close the lid B.
Selecting the temperature.
1. Put the iron in a vertical position.
2. Put the plug in the socket.
3. Adjust the thermostat knob I according to the international symbol on
the garment label [Fig. 3]. The plate temperature control light E
indicates that the iron is heating up. Wait until the plate temperature
control light goes off before ironing.
Warning: during ironing, the plate temperature control light E comes on at
intervals, indicating that the selected temperature is maintained. If you
lower the thermostat temperature after ironing at a high temperature, do not
start ironing until the plate temperature control light comes on again.
P/3 P/4