GLOBALSAT TR-151 User Manual
Page 44
C:
circular follows by one longitude, one latitude and one radius.
Example:
Rectangle
R,E12128.1883,N2342.8117,E12129.2186,N2459.8915
Example:
Circle (radius is 1000 meters)
C,E12129.2186,N2459.8915,1000
Note 4:
Example:
Send
one command to setup Geofence.
Boundary
includes
one rectangle (two longitudes and two latitudes
Æ
E12128.1883,N2342.8117,E12129.2186,N2459.8915)
When TR-151 gets out boundary, it would send format1, 10 times, 120 sec interval, alarm
message to 626123456.
$4,355632000166323,R,E12128.1883,N2342.8117,E12129.2186,N2459.8915,out,120,10,1,6161234
56!
Example:
Send
three commands to setup Geofence.
Boundary
includes
one rectangle (two longitudes and two latitudes
Æ
E12128.1883,N2342.8117,E12129.2186,N2459.8915) and two circles (one longitude/latitude is
E12228.1883,N2442.8117, and radius is 1000 meter ) ( the other longitude/latitude is
E12328.1883,N2452.8117, and radius is 1500 meter)
When TR-151 gets out boundary, it would send format1, 10 times, 120 sec interval, alarm
message to 626123456.
Command1:
$4,355632000166323,R,E12128.1883,N2342.8117,E12129.2186,N2459.8915,out,120,10,1,6161234
56!
Command2:
$4,355632000166323,C,E12228.1883,N2442.8117,1000,out,120,10,1,616123456!
Command3:
$4,355632000166323,C,E12328.1883,N2542.8117,1500,out,120,10,1,616123456!
Exit Geofence mode:
You can send a command exit Geo-fence mode.
The format of command is following as:
$2,IMEI!
Caution:
If you exit Geo-fence mode, all the settings will be deleted.
44