Trek 511 Hand-Held Electrostatic Field Meter - Manual (Page 2)

Model 511 Specifications
Performance
Measurement Range
(switch selectable)
Low Range 0 to ±2 kV / inch
High Range 0 to ±20 kV / inch
Measurement Accuracy As tested in TREK Test and Calibration
Fixture # PE15024
Voltage Monitor Output Better than ±5% of reading, ±10 mV
Voltage Display Better than ±5% of reading, ±2 counts
Measurement Stability ±10 counts
Voltage Monitor
Output 2 volts output at full scale
Ratio
Low Range 1/1000 of the measured electrostatic field
High Range 1/10000 of the measured electrostatic
field
Front Panel Meter
Voltage Display 3 ½ digit LED display
Range
Low 0 to ±1.999 kV / inch
High 0 to ±19.99 kV / inch
Display Resolution
Low Range 1 V / inch
High Range 10 V / inch
Sampling Rate 3 readings per second
Features
Ground Snap Connector Provides connection for a grounding wire
Automatic Shutoff Unit will shut off after 20 minutes from last
activity
Ranging System LED distance indicator; aligned targets
indicate one (1) inch
Range/Zero Switch LED distance indicator. Resets the
instrument to zero and selects the
measurement range
Low Battery Indicator An LCD display message indicates when
the battery is low
Features (cont.)
Hold Switch Retains the LCD display reading when
depressed
General
Dimensions 23.9 mm H x 69.9 mm W x 125.5 mm L
(0.94” H x 2.75” W x 4.94” L)
Weight 140 g (4.9 oz.) with battery
Voltage Monitor
Connection 2.5 mm jack (3/32”) monophone
Tip Signal
Sleeve Ground
Operating Conditions
Temperature 10°C to 30°C (50°F to 86°F)
Relative Humidity To 80%, non-condensing
Altitude To 2000 m (6561.68 ft.)
Power Requirements
Power One (1) 9-volt alkaline battery (not supplied)
Operating Time Greater than 50 hours, with a new battery at
21° C continuous
Power Switch A membrane switch that is designed to
prevent accidental turn on. Powers the
instrument on and off
Included Accessories
Operator’s Manual PN: 23480
Optional Accessories
Ionizer Test Kit Model: 511 Ionizer Test Kit
(comes complete with the Model 511 Field
Meter, the Model 511-CP Charge Plate and
the Model 511-CH Charger)
Certifications
Calibration
TREK, INC. certifies that each Model 511 is tested and calibrated
to specifications using measurement equipment traceable to the
National Institute of Standards and Technology. A Certificate of
Calibration accompanies each instrument when it is shipped from
the factory
CE Compliance
IEC 61010-1 Safety requirements for electrical equipment for
measurement, control and laboratory use - Part 1: General
Requirements
IEC61326-1 Electrical equipment for measurement, control and
laboratory use - Part 1: General Requirements
Copyright ã 2013 TREK, INC. All specifications are subject to change. 1326/JRB
Measurement and Power Solutions TM
www.trekinc.com