Ma x – ViTESSE VS-665 User Manual

Page 2

background image

Description of device

1. Spray organ

Filler door

3. Steam dial

Shot-steam button


Spray button


Auto shot off indication light

7. Cord bushing
8. Supply cord
9. Plate temperature control light
10. Transparent water tank
11. Thermostat knob for temperature
12. Self-cleaning button
13. Maximum filling level
14. Plate with steam vents Shot-steam button
15. Water measure






















You have made an excellent decision. Vitesse® “Nouveau” home range offers
you an exclusive, high quality range of appliances for your ultimate home
luxury and healthy living.

Important safety instructions

When using your flatiron, basic safety precautions should always be followed,
including the following:

Read all instructions before using

1. Use iron only for its intended use.
2. To protect against a risk of electric shock, do not immerse the iron in water

or other liquids.

3. The iron should always be turned to «Off» before plugging or unplugging

from outlet. Never yank cord to disconnect from outlet; instead, grasp plug
and pull to disconnect.

4. Do not allow cord to touch hot surfaces. Let iron cool completely before

putting away. Loop cord loosely around iron when storing.

5. Always disconnect iron from electrical outlet when filling with water or

emptying and when not in use.

6. Do not operate iron with a damaged cord or if the iron has been dropped or

damaged. To avoid the risk of electric shock, do not disassemble the iron
take it to a qualified serviceman for examination and repair. Incorrect
reassembly can cause a risk of electric shock when the iron is used.

Close supervision is necessary for any appliance being used by or near

children. Do not leave iron unattended while connected or on an ironing
Burns can occur from touching hot metal parts, hot water, or steam. Use
caution when you turn a steam iron upside down there may be hot water in
the reservoir.

9. If the malfunction indicator goes on, the flatiron is not operating normally.

Disconnect from the power supply and have the flatiron serviced by
qualified service personnel.

Special instructions

1. To avoid a circuit overload, do not operate another high wattage

appliance on the same circuit.

2. If an extension cord is absolutely necessary, a 10-ampere cord should be

used. Cords rated for less amperage may overheat. Care should be taken
to arrange the cord so that it cannot be pulled or tripped over.



Save these instructions
More specifically:

DO NOT let children or untrained persons use the appliance without



immerse the iron, cable or plug in any liquid.

DO NOT leave the hot iron touching fabrics or very inflammable surfaces.
DO NOT leave the appliance unnecessarily plugged in. Disconnect the plug

from the mains when the appliance is not being used.


touch the appliance with wet or damp hands.

DO NOT use the power cord or the appliance in order to pull the plug out of the


DO NOT leave the appliance exposed to the weather (rain, sun, etc. ).
DO NOT leave the iron without supervision when it is connected to the power


DO NOT fill the reservoir with water before removing the plug from the socket.

Please note!
Do not use chemical additive, scented substances or decalcifiers. Failure to
comply with the above-mentioned regulations leads to the loss of guarantee.