Velleman VDP900HZ2 - Manual (Page 4)

VDP900HZ2
V. 01 – 05/04/2013 4 ©Velleman nv
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
Familiarise yourself with the functions of the device before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the
device.
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
lamp explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
A qualified technician should install and service this device.
Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
This device is designed for professional use on stage, in discos, theatres, etc. The device should only be
used indoors with an alternating current of 230 VAC, 50 Hz.
Fog machines are not designed for permanent operation: regular operation breaks will prolong their lives.
Permanent pumping may overheat and damage the pump. A duty cycle of 30 % is advisable.
Depending on the amount of fog or haze that is produced, the device may set off smoke detectors.
Use the original packaging if the device is to be transported.
Keep this manual for future reference.
4. Features
constant output
volume control
DMX controlled by 1 channel
remote control with timer function is included
only use with VDLHLH5 haze liquid.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 remote control 6 haze outlet 11 DMX input
2 liquid level indication 7 5-pin DIN remote control connection 12 DMX output
3 haze liquid reservoir 8 display 13 control buttons
4 cap 9 fuse holder 14 on/off switch
5 tube 10 power cord
6. Installation
6.1 Installation Notes
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
The installation must always be secured with a secondary attachment e.g. a safety cable.
Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used… Have the material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation may result in injuries.
For sufficient air circulation, leave at least 30 cm on all sides. Keep the outlet at a minimum distance of
40 cm from any obstacle. Make sure there is no flammable material within a 0.5 m radius of the device.
Have a qualified electrician carry out the electric connection.