Velleman VRC801D2 - Manual (Page 4)

VRC801D2 VELLEMAN
- 4 -
d. Deleting All Learned Commands in the Remote Control
Use this function if you would like to delete all learned
commands in the VRC801D2.
• Hold the SET key pressed for 3 seconds.
• Select LEARNING using the or the button and press
OK.
• Select DELETE ALL using the or the button and
press OK.
• SURE DELET appears on the LCD. Press OK to confirm.
All the learned commands have been deleted.
5. Macros
A macro is a succession of operations set into one press of a button.
a. Setting Up a Macro
• Hold the SET key pressed for 3 seconds.
• Select the MACRO using the or the button and press OK.
• Select MACRO 1, MACRO 2 or MACRO 3 using the or the button and press OK.
• SET UP appears on the LCD. Press OK to confirm.
• SELECT KEY appears on the LCD. Select a device and the function(s) you wish to set up, e.g. VCR + POWER + REC if you
wish to turn on your VCR player and start to record.
• Press OK to save the settings. SUCCESS appears on the LCD. Press the or the button to set another macro or press
any key to exit the mode.
Remark: - One macro can contain a maximum of 10 commands.
- Ensure that all the keys can transmit signals. Check the key function prior to setting the macro.
- Observe that a macro will only be executed under certain conditions, e.g. the VCR player must contain a cassette if
you wish to record.
b. Operating a Macro
Hold the MACRO key pressed and press 1, 2 or 3 (depending on the desired macro). The remote control will execute the
sequence of programmed functions.
c. Deleting a Macro
• Hold the SET key pressed for 3 seconds.
• Select the MACRO using the or the button and press OK.
• Select DELETE using the or the button and press OK.
• SURE DELET appears on the LCD. Press OK to confirm.
• Press OK to save the settings. SUCCESS appears on the LCD. Press the or the button to delete another macro or
press any key to exit the mode.
6. Other Functions
a. Setting Up the Clock
• Hold the SET key pressed for 3 seconds.
• Select CONFIGURE using the or the button and
press OK.
• Select TIME SETUP using the or the button and
press OK.
• Use the or the button to select the hour, minute and
AM/PM. Set the time using the numeral keys, set AM/PM
using the or the button. Press OK.
• Press EXIT to quit.