Velleman WELD-101 - Manual (Page 2)

WELDING TORCH
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that
disposal of the device after its lifecycle could harm the
environment. Do not dispose of the unit (or batteries) as
unsorted municipal waste; it should be taken to a specialized
company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local
environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before
bringing this device into service. If the device was damaged in transit,
don't install or use it and contact your dealer.
This is a high-quality product tested individually and guaranteed in
order to provide safe and excellent performance. Note that the
connection to the gas cylinder must be made with a rubber hose
approved by the laws of the country of use.
2. Before Use
Make sure the rubber hose is in good condition, the connection of the
rubber hose to the cylinder with hose clamps is tight and that the
rubber can withstand the pressure.
3. Ignition
Open the cylinder tap and turn on slowly the tap of the torch. Bring a
flame just under the burner.
4. Use
Adjust the flame intensity by opening or closing the tap. In case the
device is provided with an opening lever, reduce the flame to its
minimum by turning the knob and operate the lever to get the suitable
flame intensity. The lever’s release involves an automatic and
immediate return to the minimum flame setup.
5. Maintenance
The use of dirty gas coming from the cylinder bottom may cause a
partial blocking of the jet. To clean it, remove the burner and the
injector, and wash carefully with gasoline or a similar product, or with
thin wire. Do not widen the injector.