Velleman VDPL1210MHRGBW - Manual (Page 6)

VDPL1210MHRGBW
V. 02 – 26/09/2013 6 ©Velleman nv
3. Press <UP> or <DOWN> to change the setting.
4. Press <ENTER> to confirm (or press <MENU> to cancel).
The menu contains the following items:
Menu item Menu function
DMX Address Sets the DMX address
Channel Mode Sets the channel (9, 14, 16, or 28 channels)
Show Mode Sets the built-in program type
Slave Mode Sets the slave mode
Slave1 = exact copy of master
Slave2 = offset pan and tilt)
Black out Set this option to Yes to stop a built-in program.
When set to Yes, the device will not play any built-in program when
powered up.
When set to No, the device will automatically start playing the last
built-in program..
Sound State Turns sound activation on or off
Sound Sense Sets the sound sensitivity
100: maximum sound sensitivity.
0: no sound sensitivity
Pan Inverse Turns reverse pan on or off
Tilt Inverse Turns reverse tilt on or off
Back Light Turns the display light on or off.
On: display remains on.
Off: display turns off after 1 minute.
White Balance Sets RGB adjustement
Manual Test Manually tests the fixture's Pan, Tilt, colours, Dimmer and Strobe.
Press <ENTER> to stop the test.
Press ENTER to access the menu.
Use UP or DOWN to select the item you want to test and press
ENTER.
Use UP or DOWN to set the item's value and press ENTER.
@@@
Auto Test Performs a series of automatic tests.
Press <ENTER> to stop the test.
Temp. Shows the fixture’s temperature.
Fixture Time Displays the number of working hours
PRO defaults Resets all the fixture's settings to factory settings
Reset Resets the fixture to its original position.
7.2 Stand-Alone Mode
In stand-alone mode, the LEDs of the device will synchronize with the music through the built-in
microphone.
To set the device to stand-alone mode:
1. Connect nothing to the DMX input of the device.
2. Press <MENU> until <SOUND MODE> is displayed and press <ENTER>.
3. Press <UP> or <DOWN> to select the desired setting:
o
100: maximum sound sensitivity.
o
0: no sound sensitivity.
4. Press <ENTER> to confirm.
5. If necessary, set the sensitivity of the internal microphone with the menu option Sound Sense.
7.3 Master/Slave Mode
The master/slave mode allows connecting several devices to a single master device. All slave devices will
then work synchronously with the master device.
You need to set one device to master mode and all other devices to slave mode.