Velleman VDPLP56SB2 - Manual (Page 4)

VDPLP56SB2 / VDPLP56SC2_v4 HQPOWER 4
5. Use
• Auto: DIP switches as below (X means ON, 0 means OFF)
Mode Dip10 Dip9 Dip8 Dip7 Dip6 Dip5 Dip4 Dip3 Dip2 Dip1 Function
Auto run
(master
projector)
0 0
X X 0 0 0 0 0 0
Colour changing and fading.
Select running speed via dip
7-8.
0 0 X X X X X X
Static colour and flash. Select
colour via dip 1-3, and flash
speed via dip 4-6.
Sound
activated
(master
projector)
0 1 X X X X X X X X
Sound-activated colour
change.
DMX 1 X X X X X X X X X
DMX mode
CH1 → R CH2 → G
CH3 → B CH4 → Dimmer,
strobe
Other
1 0 0 0 0 0 0 0 0 1
1. DMX address is 1 when in
DMX mode.
2. As slave projector when in
M/S mode.
1 0 0 0 0 0 0 0 0 0 Black-out
• DMX512 mode:
Press 10 to ON to receive the DMX signal. 1-9 are used to select the requested address.
1 2 3 4 5 6 7 8 9 10
1 2 4 8 16 32 64
128 256 *
Example: If the start address should be 95 the settings would be (for switches 1-10): 1111101000 (1 + 2 + 4 + 8 +
16 + 0 + 64 = 95).
This unit has 4 channels. Refer to the functions below:
Ch 1: 0-255 Red dimmer
Ch 2: 0-255 Green dimmer
Ch 3: 0-255 Blue dimmer
Ch 4: 0-189 Dimmer
190-250 Strobe
251-255 No function
DMX512 Connection
Connect an XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-pin XLR
input of the VDPLP56SB2 / VDPLP56SC2. Multiple VDPLP56SB2 / VDPLP56SC2s can be linked through serial
linking. The linking cable should be a two-core screened cable with XLR input and output connectors.