Velleman VDLMM1S - Manual (Page 3)

VDLMM1S HQPOWER 3
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
• The installation has to be approved by an expert before the device is taken into service.
• Connect the device to the mains with the power plug. Don’t connect it to a dimming pack.
4. Description
1. mirror ball motor
2. axle
3. chain link
4. lifting chain
5. installation eyelet
6. mirror ball
7. attachment eyelet
8. safety chain
9. attachment eyelet
cable pin code
brown live L
blue neutral N
yellow/green earth
Use both chains to fix the mirror ball: the lifting chain (4) which will hold the mirror ball and the safety chain (8) which
will hold the chain in case the lifting chain breaks. Both chains have to hold 10 times the weight of the mirror ball and
the chains for one hour without any deformation. The safety chain must be stronger than the lifting chain. The max.
length of the safety chain must not exceed 100cm. Please examine the complete system regularly. Every deformed
must be changed immediately.
5. Installation
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service. Only install and service the system when
area under the system is blocked.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used… Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Only use the appropriate screws and pegs and make sure that the screws are properly connected to the
installation area.
• Mount the motor directly onto the mounting surface.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.