Operation, Bank notes with uv-sensitive markings, Bank notes with non uv-sensitive markings – Velleman ZLUV220 User Manual

Page 3: Most counterfeit bank notes, Replacing a uv lamp

Advertising
background image

ZLUV220 – ZLUV220/2

V. 03 – 14/06/2013

3

©Velleman nv

Damage caused by disregard of certain guidelines in this manual is not

covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.

Keep this manual for future reference.

3. Operation

Switch on the money detector.
Bank notes with UV-sensitive markings:
Place the bank note under the UV light of the detector. The UV-sensitive
markings will appear.
Bank notes with non UV-sensitive markings:

Place the bank note under the UV light of the detector. No UV-sensitive

marking will appear and the bank note’s texture will not change. No
watermark will be visible.

The holographic indicia will be visible on the front of the bank note but

not on the back.

Most counterfeit bank notes:

Place the bank note under the UV light of the detector. The counterfeit

bank note will immediately glow blue. The watermark will not be visible,
unlike the holographic indicia which will be highly visible, both on the
front and on the back of the bank note.

All counterfeit bank notes are fluorescent. If in doubt, verify the

watermark: it must be very clear with well-defined colours. A bank note
which is not too used must feel crisp and be slightly rough on the prints.

The bank note must not be limp, shiny or waxy.

Attention: This money detector has a black plastic housing and features

one (ZLUV220) or two (ZLUV220/2) blue UV lamps. Do not place the
detector at eyes height to prevent eye damage.
Each lamp has a lifetime of 2,000 to 4,000 hours.

4. Replacing a UV lamp

1.

Disconnect the detector from the mains.

2.

Unscrew the screws holding the lamp support.

3.

Twist the lamp slightly and carefully in order to dislodge the lamp.

4.

Replace the lamp with an exact type of lamp.

5.

Insert the new lamp. Carefully turn the lamp to click in place.

6.

Reinstall the support and fix with the screws.

Advertising