Velleman VDL660LON - Manual (Page 3)

VDL660LON
03.05.2013 ©Velleman nv 3
3. General Guidelines
Refer to the Velleman ® Service and Quality Warranty on the last pages of this manual.
 This device is designed for professional use on stage, in discos, theatres, etc. The
VDL660LON should only be used indoors with an alternating current of 230VAC/50Hz.
 Lighting effects are not designed for permanent operation: regular operation breaks will
prolong their lives.
 Do not shake the device. Avoid brute force when installing or operating the device.
 Select a location where the device is protected against extreme temperatures, dust and
moisture. Respect a minimum distance of 0.5m between the device’s light output and any
illuminated surface.
 Familiarise yourself with the functions of the device before actually using it. Do not allow
operation by unqualified people. Any damage that may occur will most probably be due to
unprofessional use of the device.
 Use the original packaging if the device is to be transported.
 All modifications of the device are forbidden for safety reasons.
 Only use the device for its intended purpose. All other uses may lead to short circuits,
burns, electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way
will void the warranty.
4. Installation
a) Lamps
 Only fit or replace a lamp when the device is unplugged from the mains.
 Let a lamp cool down before replacing it.
 Do not install lamps with a higher wattage than that for which this device was designed.
 Replace any deformed or damaged lamp with a lamp of the same type.
b) Mounting the Device
 Have the device installed by a qualified person, respecting EN 60598-2-17 and all other
applicable norms.
 Install the device in a location with few passers-by that is inaccessible to unauthorised
persons.
 Make sure there is no flammable material within a 50cm radius of the device.
 Have a qualified electrician carry out the electric connection.
 Connect the device to the mains with the power plug. Don’t connect it to a dimming pack.
 The installation has to be approved by an expert before the device is taken into service.
5. Use
All controls are on the centre module. Switch the device on and off by means of the ON/OFF
switch. Do not operate the device continuously.
Adjust the sensitivity of the 3 channels (2 opposed lamps compose 1 channel) by means of
the 3 rotary controls (bass, middle and high – each channel reacts to a different frequency
area) until the reaction of the lamps to the music satisfies you.
6. Cleaning and Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing and the installation location should not be deformed, modified or tampered
with.
3. The electric power supply cables must not show any damage. Have a qualified technician
maintain the device.
4. Disconnect the device from the mains prior to maintenance activities.
5. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
6. There are no user-serviceable parts, apart from the lamp (see “4. Installation”).
7. Contact your dealer for spare parts if necessary.