Velleman VDPC130 - Manual (Page 6)

VDPC130_v3 VELLEMAN 6
• Checking a CHASER
Select the desired chaser using the CHASER buttons (22). Press TAP / DELAY (17). The display will show the
steps in the chaser. Press the BANK buttons (16 and 17) to see each scene.
• The PAGE selection button (10)
Use this button to adjust the channel faders (4) from CH1 ~ 8 (page A LED is lit) to CH9 ~ 16 (page B LED is lit)
or both of them (both LEDs are lit).
• The DISPLAY button (17)
Use this button to switch the display from a DMX value (0 ~ 255) to a percentage (0 ~ 100%).
b. Programming
A bank is a sequence of different scenes that will be called up one after another. With the VDPC130, you can
program up to 30 different banks, each bank containing up to 8 scenes.
• Assigning a Jog Wheel to a Channel
o Choose your channel.
o Press MIDI / REC (19) to confirm.
• Programming a Scene
o Press and hold the PROGRAM button (11) for 2 seconds to enter the programming mode. The PROGRAM
LED will flash.
o Select the desired scanner using the SCANNER selection buttons (1).
o Adjust the settings (the value will be shown in the display) using the respective CHANNEL faders (4).
o Press the MIDI / REC (19) to prepare saving mode.
o Select the desired bank (01 ~ 30) which will be saved through the BANK buttons (15 and 16).
o Press one of the SCENE buttons (3) in order to save the data. All LEDs on the panel will flash indicating the
data is saved.
o Select the next scanner using the SCANNER selection buttons (1) and repeat the steps above until
programming is finished or the maximum number of steps (8) has been reached.
o Press and hold the PROGRAM button (11) to exit the programming mode.
• Running a Program
o Press the BANK buttons (15 and 16) and select the desired bank.
o Press the AUTO / DEL button (21). The auto LED will light.
o Adjust the speed using the SPEED fader (23) and the repetition rate using the FADE TIME fader (24).
o You can also adjust the speed by pressing the TAP button (17) twice. The time interval between two presses
determines the speed (up to 10 minutes).
• Checking a Program
o Press and hold the PROGRAM button (11) and select the desired bank using the BANK buttons (15 and 16).
o Check every scene individually by pressing the respective SCENE button (3).
• Editing a Program
o When programs have to be edited, it is necessary to modify a scene manually.
o Press and hold the PROGRAM button (11) to enter the programming mode.
o Select the program to be edited using the BANK buttons (15 and 16).
o Select the desired scanner using the SCANNER buttons (1).
o Adjust the desired settings using the respective CHANNEL faders (4).
o Press the MIDI / REC button (19) to prepare for saving.
o Select the desired scene using the SCENE button (3) and save.