Velleman PIR416 - Manual (Page 5)

PIR416
V. 04 – 26/07/2013 5 ©Velleman nv
6. Connect the wiring [1] to the terminals according to the diagram
on page 2. Wire colours:
x red (+) y black (-) z brown
Warning: do not short-circuit any terminals.
7. Connect the power supply.
8. To test the PIR sensor, set the light sensitivity to OFF and the
movement sensitivity and 5” to ON. The load should switch on
immediately and – when no movement is detected – switch off
after 5 s.
Note: DO NOT change the DIP switch settings when power is
connected!
5. Technical Spe cifications
switch type
relay
detection angle 100°
detection range 8 m (@ 22 °C)
rated load 25 W resistive load
(max. inrush current 2.1A)
input 12 Vdc, 2.6 A
output max. 12 Vdc 2.5 A / 25 W
working temperature -10 °C to +40 °C
working humidity
< 93 % RH
time-delay switch 5 s, 30 s, 1 min, 3 min, 5 min, 8 min
light control < 3 lx to 2000 lx
dimensions visible part Ø 22 x 10 mm
hidden part (controller) 55 x 25 x 35 mm
weight ± 41 g
Use this device with original accessories only. Velleman nv
cannot be held responsible in the event of damage or injury
result ing from (incorre ct) use of this dev ice. For more info
concerning this product and the latest version of this manual,
please v isit our we bsite www.velleman.eu. The information in
this manual is subject to change without prior notice.