Velleman EFANF60 - Manual (Page 2)

EFANF60_v2 PEREL 2
EFANF60 – HIGH-VELOCITY DRUM FAN - 24"/60cm
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to
a specialized company for recycling. This device should be returned to your distributor or to a local recycling
service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the EFANF60! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorized dealer replace it if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• Do not use this fan with a speed-control device.
• Never insert fingers or any other object through the grille when the fan is running.
• This fan is only suited for indoor use.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
3. Operating Instructions
• Place the fan on a flat and sturdy surface.
• Insert the power plug into the mains.
• Adjust the desired speed by rotating the speed button: 0 = STOP, 1 = LOW, 2 = MEDIUM, 3 = HIGH.
• Adjust the tilt angle by pushing the grille.
• Switch off and unplug from the mains after use.
4. Cleaning and Maintenance
• Disconnect the device from the mains prior to maintenance activities.
• Clean out the parts with a soft and dry cloth. Remove stains with a damp cloth and some mild soap. Remove
soap remnants with the damp cloth.
• Ensure that water or any other liquid does not enter the fan motor housing or the speed control unit.
Keep this device away from rain and moisture.
Unplug the mains lead before cleaning or disassembling.