Velleman LDRB65HS - Manual (Page 15)

15
IT
ALIANO
POLSKI
ESP
Añ
OL
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH
SYSteM SettInGS AnD oPeRAtIonS:
USING THE WIRED MICROPHONE INPUT
Plug the 6.3 mm Jack connector of your microphone cable into the MIC Jack input. You will find this input on the
back panel of your Roadboy. Make sure that the other end of your cable is correctly connected to the microphone.
If your microphone features an ON / OFF switch, please set it to the ON position. Now use the MIC gain knob to set
the balance between the MIC and LINE inputs. Too much MIC level can cause distortion (Overdrive).
USING WIRELESS MODULE
Start by setting the MASTER level knob of your Roadboy on the zero position. Then turn the POWER-VOL knob of
the wireless module to twelve o’clock position. Now you can synchronize the transmitter (handheld mic or Belt
Pack) with the integrated receiver thanks to the ASC function: Press the ASC button of the wireless receiver modu-
le, the ASC LED now flashes red.
If you are using a handheld transmitter: The Infrared sensor (IR) is placed in the battery compartment under
the capsule. Hold it close to the IR sensor of the wireless receiver module.
If you are using a Belt Pack transmitter: You need to activate the ASC function on the Belt Pack also. Then
hold the Infrared sensor (IR on the rear side) of the belt pack transmitter close to the IR window of the wireless
receiver module. The synchronization lasts a few seconds. If you have installed a second wireless module (opti-
onal), make sure that you are not running both modules on the same frequency in order to avoid any interference
(see frequency list). A flashing RF light shows that your system is functioning and that the synchronization was
successful. You can now increase the MASTER volume of your Roadboy to the desired volume.
Maximum distance between the wireless microphone (or Belt Pack transmitter) and the receiver module is around
60 m in an open space.
USING THE „EXT. SPEAKER“ OUTPUT
Use a speaker cable with 6.3 mm Jack connector to connect the external loudspeaker. Use a speaker with impe-
dance between 4 and 8 Ohm with a minimal power output of 25 W.
CHARGING ROADBOY
Plug the power supply (16 V / 3 A) which is included with your Roadboy to operate your system without batteries
or in order to charge the batteries. The charging time is 8 hours. The charging procedure stops automatically when
the battery is fully charged. You can also keep the Roadboy connected to the AC current and operate it as long as
you wish.
IMPORTANT!
When connecting the battery for the first time or when replacing the battery you MUST mind the
polarity! Red = + (plus) // Black = - (minus).
When the Roadboy is charged for the first time, charging time should be 15 hours. This increases both
battery life and capacity. This procedure should be repeated every 2-3 months. Before this charging
procedure the battery should be empty.