Velleman CAMCOLVC18 - Manual (Page 9)

CAMCOLVC18
V. 04 – 06/09/2013 9 ©Velleman nv
5. Wait until the display shows the remaining recording time again.
The card is now empty and ready for use with the camera.
7.4 Configuration
Setting the video resolution
You can set the resolution of the recorded video to 720p (1280×720) or
VGA (640x480).
To set the resolution:
1. Switch the camera on.
2. Press and hold the menu button for 2 seconds.
The 720p icon blinks.
3. Press the record button once to switch to VGA. The VGA icon
blinks.
4. Press the menu button to confirm.
Note: The remaining recording time is adjusted to the resolution. You can
record longer in VGA mode (lower resolution) than in 720p mode.
Setting the time and date
1. Switch the camera on.
2. Press and hold the menu button for 2 seconds.
The 720p icon blinks.
3. Press the record button repeatedly until “ALL” appears on the display.
4. Press the menu button for 2 seconds.
“Y” (for “year”) and the third digit of the year blink on the display.
5. Press the record button repeatedly to set the digit. Then press the menu
button to confirm and move to the next digit.
6. Repeat for the last digit of the year, the month (“M”), day (“D”), hour
(“H”), and minutes (“M”).
The camera returns to video recording mode after you set all the digits.
7.5 Recording video
Normal recording
1. Make sure there is a memory card installed in the camera.
2. Switch the camera on. The display shows the remaining recording time.
3. Press the record button to start recording.
The display backlight blinks. The display shows the recording time in
minutes and seconds. The camera saves a video file every 5 minutes.
4. Press the record button again to stop recording.
The display backlight stops blinking. The display shows the remaining
recording time.
Note: When the memory card is full, the display shows “FULL”. The camera
automatically stops recording.