Velleman IVSPROM1 - Manual (Page 11)

IVSPROM1
09.11.2010 ©Velleman nv 11
• AUDIO (SLOW + ZOOM)
Press “SLOW” + “ZOOM” to select live or playback audio from audio channel 1~4.
Live audio from audio channel 1~4
(indicated in white). Playback audio from audio channel 1~4
(indicated in yellow).
Audio channel unselected
• P.T.Z. ( + SEQ)
Press “ ” + “SEQ” at the same time to enter or exit the PTZ control mode.
• USB port
There are two USB ports on the front panel, one for connecting a USB mouse for mouse control, and the
other one for connecting an USB flash drive for video backup.
Note: Do not connect two USB mice or two USB flash drives simultaneously.
Note: For compatible USB flash drive list, please refer to “APPENDIX 3” in the full user manual.
7.2 Rear Panel
• VIDEO IN (1 ~ 4): Connect to the video connector of a camera.
Note: The DVR will automatically detect the video system of the camera; make sure that the cameras are
properly connected to the DVR and powered before the DVR is turned on.
• AUDIO IN (1~4)
Connect to the audio connector of a camera if the camera supports audio recording.
Note: To make a video backup with audio, make sure the camera which supports the audio function is
connected to the video-in channel and audio-in channel. For example, the audio data from audio CH1 will
be recorded with the video data from video CH1.
• AUDIO OUT
Mono audio output to connect to a speaker.
• MONITOR
Connect to a CRT monitor for video output.
Note: When both MONITOR and VGA are connected, press the left key ◄ on the DVR front panel during
DVR power-on to force the video output via MONITOR. For details, refer to §5.5.
• CALL
Connect to a monitor specific for sequence display.
• VGA
Connect to a LCD monitor directly.
Note: When both MONITOR and VGA are connected, press the right key ► on the DVR front panel during
DVR power-on to force the video output via VGA. For details, refer to §5.5.
• IR
Connect an IR receiver extension line (not incl.) for remote control.
• EXTERNAL I/O
This port is used to connect external devices (such as speed dome cameras or external alarm, etc).
• LAN
Connect to Internet by LAN cable.
• DC 19V
Connect to the supplied adapter.
• Power Switch
Switch to “|” to turn on the power, to “|” to turn off the power.
8. Basic operation
Note: some of the features and functions described below only apply to the human detection camera.
8.1 Live page
Refer to the image below.
1 system time 4 recording icon
2 status bar 5 channel
3 available disk capacity 6 motion icon