Velleman MONCOLH2 - Manual (Page 5)

MONCOLH2
09.06.2010 ©Velleman nv 5
• Only use the device for its intended purpose. Using the
device in an unauthorised way will void the warranty.
• Damage caused by disregard of certain guidelines in this
manual is not covered by the warranty and the dealer will
not accept responsibility for any ensuing defects or
problems.
4. Overview
Refer to the illustrations on pages 2 and 3 of this manual.
MONCOLH2 5
wrist strap brace
1 LCD 6 charge indicator
2 On/Off 7 battery compartment
3 brightness 8 power input
4 colour 9 video input
Connection C video cable
A monitor C1 video input
B power adaptor C2 power output (5VDC)
5. Use
• Before use, make sure the battery is fully charged. To do
this, plug the power adaptor [B] into the power input [8].
The charge indicator [6] lights up bright. When the battery is
full, the charger indicator dims. Disconnect the adaptor.
• Attach the wrist strap as indicated on page 3.
• Plug in the included signal cable [C] into the video input [9].
• Connect the other end [C1] to video output of a camera (not
incl.).
Note: do not connect the power output [C2] to the camera
as most cameras require 12VDC and this connector
only provides 5VDC.
• Switch on the LCD [1] with the On/Off button [2].
• The monitor now shows the camera images.
• Press the brightness button [3] until the desired display
brightness is reached (8 steps, circular).
• Press the colour button [4] until the desired display colour is
reached (8 steps, circular).
• Switch off the monitor before disconnecting the video cable.
Remember to reconnect the camera to the fixed wiring.
6. Battery
• The MONCOLH2 contains an internal rechargeable battery.
When the device is end-of-life, this battery has to be
disposed of in accordance with local regulations.
• Open the battery compartment [7] and remove the battery.