Velleman LX106 - Manual (Page 6)

LX106/LX107
V. 05 – 15/05/2013 6 ©Velleman nv
Stand-Alone Mode with Built-in Program
To set the device to stand-alone mode with a built-in program:
1. Connect nothing to the DMX input [4,12] of the device.
2. Press <MENU> until <P--> is displayed and press <ENTER>.
3. Use <UP> and <DOWN> to select one of the built-in programs (P1 – P5) and press <ENTER>:
o P1: 15 colours, fading 0 % – 100 % – 0 %
o P2: 15 colours, fading 0 % – 100 %
o P3: 15 colours, fading 100 % – 0 %
o P4: colour macros, fading
o P5: loop running P1 – P4.
After you select a program, you set the speed of the program.
4. Use <UP> and <DOWN> to set the speed from <S--0> (slow) to <S100> (fast).
5. Press <ENTER> to confirm.
Sound Control
To activate sound control:
1. Press <MENU> until <SUND> is displayed and press <ENTER>.
2. If necessary, set the sensitivity of the internal microphone with the sensitivity regulator [5,15].
Stand-Alone Mode with Built-in Static Colour
To use one of the built-in static colours:
1. Connect nothing to the DMX input [4,12] of the device.
2. Press <MENU> until <C--> is displayed and press <ENTER>.
3. Use <UP> and <DOWN> to select a colour (C1 – C15) and press <ENTER>.
C1 Red C6 Red + blue C11 Green + white
C2 Green C7 Green + blue C12 Red + blue + white
C3 Blue C8 Red + green + blue C13 Green + blue + white
C4 White C9 Red + white C14 Red + green + white
C5 Red + green C10 Blue + white C15 Red + green + blue + white
Stand-Alone Mode with Custom Static Colour
You can create a custom colour by adjusting the intensity of the red, green, blue, and white LEDs. Also, you can
specify a strobe rate with the custom colour.
To use a custom static colour:
1. Connect nothing to the DMX input [4,12] of the device.
2. Press <MENU> until <U--> is displayed and press <ENTER>.
The intensity setting for the first colour appears, for example <r-50> (red 50%).
3. Use <UP> and <DOWN> to set the intensity of the colour from 000 to 100 and press <ENTER>.
The intensity setting for the next colour appears.
4. Set the intensity for all colours (<r--> for red, <g--> for green, <b--> for blue, <w--> for white) until you
have the desired output colour.
5. To set the strobe rate, press <ENTER> until <S--> appears on the display.
6. Use <UP> and <DOWN> to set the strobe rate (S0 to set the strobe off, S1 – S20 for strobe speed slow to
fast) and press <ENTER>.
Dimmer Adjustment
You can manually control the dimmer speed. To set up the desired dimmer speed:
1. Press <MENU> until <DIM> is displayed and press <ENTER>.
2. Use <UP> and <DOWN> to select the desired setting:
o <OFF>: dimmer off.
o <DIM1> – <DIM3>: dimming speeds 1 to 3.
3. Press <ENTER> to confirm.