Velleman LPTDX1220 - Manual (Page 2)

LPTDX1220 GB 2
• Do not crimp the power cord and protect it against damage from sharp edges. Ask an
authorised dealer to replace the cord if necessary.
• Always disconnect the device from the mains when it is not in use or when you wish to clean
it. Only handle the power cord by the plug. Never pull out the plug by tugging the power cord.
• Do not look directly into the light source as sensitive people may go into epileptic seizure if
they do.
• Note that damage caused by user modifications to the device is not covered by the warranty.
Keep the device away from children and unauthorised users.
3. General Guidelines
• This device is a lighting controller for professional use on stage, in discos, theatres, etc. The
LPTDX1220 should only be used indoors with an alternating current of max. 230Vac/50Hz.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device will be protected against extreme heat, moisture and dust.
• Do not use or transport the device under temperatures < 5°C or > 35°C.
• Familiarise yourself with the functions of the device before actually using it. Do not permit
operation by unqualified people. Any damage that may occur, will probably be due to
unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• Note that all modifications of the device are forbidden for safety reasons.
• Do not remove the serial number sticker from the device as doing so will void the warranty.
Only use the device for its intended purpose. All other uses may lead to short-circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void
the warranty.
4. Installation
Mount the device in your rack. Connect the spots or light effects to the screw connectors at the
back of the device (see figure below : 21-28). Connect your DMX controller to the DMX IN
socket with a 5-pole DMX cable. Connect the second device to the DMX OUT of the first device
when connecting several LPTDX1220's to your DMX controller.
The device will always power on in the mode it was last used.