Velleman GMK1LAMP - Manual (Page 3)

GMK2LAMP
00 (13/08/2008)
3
USER MANUAL
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that
disposal of the device after its lifecycle could harm the
environment. Do not dispose of the unit (or batteries) as
unsorted municipal waste; it should be taken to a
specialized company for recycling. This device should be
returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before
bringing this device into service. If the device was damaged in transit,
don't install or use it and contact your dealer.
2. Safety Instructions
Do not use any liquids when cleaning the traps’ internal
parts. Only use the brush that came with the mosquito trap.
Do not stare at the light from the UV-lamp. Permanent eye
damage may occur.
Keep this device away from rain and moisture.
3. Replacing the UV-lamp
Refer to the pictures of this manual.
• Switch off the lamp and disconnect from the mains.
• Remove the collecting container by twisting the container counter
clockwise and pull. Now, twist the lamp holder section and pull from
the fan section.
• Gently unstick the electrical wire. Remove the 4 screws to uncover
the PCB. Now, slide the PCB out of the notches.
• Unsolder the connections of the lamp to the PCB. Remove the lamp
and replace with a new one. Solder the connections to the PCB.
Slide the PCB back into the notches.
• Screw the PCB holder back into the lamp holder section with the 4
screws.
• Reassemble by repositioning the lamp holder section back onto the
fan section and by twisting the container back onto the assembly.
For more info concerning this product, please visit our website
www.velleman.eu. The information in this manual is subject to
change without prior notice.