Velleman CAMCOLBUL27 - Manual (Page 4)

CAMCOLBUL27
16.12.2010 ©Velleman nv 4
• with B/W night vision (IR LEDs)
• super high resolution
5. Overview
Refer to the illustrations on page 2 of this manual.
1 lens 5 position bolt
2 IR LEDs 6 bracket
3 light sensor 7 camera bolt
4 sunshield
6. Hardware installation
Refer to the illustrations on page 2 of this manual.
• Choose a location for the camera, keeping following guidelines in mind:
o do not install the camera in locations where extremely high or low
temperatures or excessive vibrations may occur.
o avoid mounting the camera near high electro-magnetic fields.
o do not aim the camera at the sun or other extremely bright objects or
reflections (e.g. metal doors).
• Use the mounting bracket [6] to determine the location of the mounting
holes. Drill the holes and secure the bracket [6] using 3 screws.
• Attach the camera to the mounting bracket [6] with the camera bolt [7].
• Connect the power connector [B] to the 12VDC power supply (not incl.).
• Connect the BNC connector [A] to a monitor (not incl.)
• Point the camera towards the field of interest and tighten the position bolt
[5].
7. Technical specifications
pick-up element
1/3" HR colour CCD image sensor -SONY Effio
DSP
pixels 753(H)x582(V) PAL
horizontal resolution 600 TV lines
min. illumination 0.1 Lux (F2.0) ; 0 Lux (IR on)
IR LEDs 21
range (IR light) 15m
S/N ratio > 48dB (AGC off)
water-resistance IP67
electronic shutter
1/50 to 1/100000s
lens angle 92.6°
Colour Rolling Suppress yes
white balance automatic
AGC yes
standard board lens
f3.6mm / F2.0
video output 1Vpp @ 75 ohms