Velleman KSR8 - Manual (Page 7)

KSR8 - 7 - VELLEMAN
6. Description
1. Power switch
2. IR transmitter
3. Shooting indicator (yellow LED)
4. Life indicator (green LEDs)
5. Receiver
6. Buzzer
1. IR transmitter
2. Shooting button
3. Control buttons
4. Power switch
5. Power indicator
6. Channel switch
7. Operation
1.
Select the channel (A, B, C or D) on your IR remote control first and turn on afterwards. The red LED lights. Once
your remote control switched on, you will not be able to change the channel.
2. Next, switch on your Titan Tank. Point the remote control at the tank and push any button for 3 to 5 seconds. The
buzzer will beep and the green LEDs will light sequentially. The built-in receiver has recognized the selected
channel. Repeat this step every time you switch on your remote control and your tank or when you wish to reset
the channel. It is recommended to set the channels one by one when playing with more than 2 players.
3. Your tank can make 8 different movements. Refer to the chart below. The more you practice, the easier you will
control your tank.
4. There is a 2-second delay between two shots. The yellow LED lights when the tank is ready to shoot.
5. If your tank is hit by another Titan Tank, the green LED will turn off and your tank will turn 2 circles. Once hit 4
times (all 4 green LEDs are turned off), your tank will keep turning and make a siren sound. Turn off both your
remote control and your tank and repeat steps 1 and 2 to play again.
8. Troubleshooting
• Make sure all components on the PCB are in the right position. Make sure all batteries are correctly inserted.
Respect the polarity.
• Ensure all wiring is correctly connected.
• If you are not able to shoot other tanks, check if the wiring from the barrel to the PCB is not reversed.
• Adjust the barrel to the proper shooting angle.
The information in this manual is subject to change without prior notice.
Fig. 4
Fig. 5