ACP RCS511TS Owner's Manual - Manual (Page 8)

8
Using the Oven Control
(Electronic Control)
Manual Time Entry
To cook food using a specific entered time and power level.
1. Open oven door and place food in oven. Close door.
• READY displays. Fan and light will turn on.
2. Press TIME ENTRY key.
• READY and 0000 display.
• If pad does not work, open and close oven door and try again.
3. Enter cooking time by using the numbered keys.
4. Press a power level key to change power level if desired.
• POWER LEVEL displays with the power setting.
-
00 indicates 0% microwave power, 20 indicates 20%, 50
indicates 50% and 70 indicates 70% microwave power. If a
number is not displayed with POWER LEVEL the microwave is set
to full power.
5. If stage cooking is desired, press TIME ENTRY key and repeat steps 3
through 4.
• Display changes to cook time and power level for the next stage.
6. Enter cook time and power level as in steps 3 and 4.
• To add another cooking stage press TIME ENTRY key again.
• Up to four different stages can be programmed.
7. Press START key.
• Oven operates and time counts down.
• POWER, COOK LEVEL and cooking time display.
8. At end of cooking cycle oven beeps and shuts off.
Programmed Keys
To cook food using keys preprogrammed with cooking sequences.
1. Open oven door and place food in oven. Close door.
• READY displays. Fan and light will turn on.
2. Press desired key.
• For single key entry, press only one key.
• For double key entry, press the two keys, in order, of the double digit
number for the desired cooking sequence.
• To change single or double key entry option
see User Options section in this manual.
3. Oven begins to cook.
• POWER, power level and total cooking time display. If power level does
not display, microwave is cooking at full power.
• For additional cooking time, press preprogrammed key again
to begin cooking sequence again.
4. At end of cooking cycle oven beeps and shuts off.
Factory Settings
Pad Time Pad Time
1 10 sec. 6 1:30 min.
2 20 sec. 7 2 min.
3 30 sec. 8 3 min.
4 45 sec. 9 4 min.
5 1 min. 0 5 min.
QTY X2 Key
To increase cooking time
by a specific cooking factor when
cooking more than one serving.
The cooking factor is a percentage
of the original cooking time (from
10 to 100%).
1. Open oven door and place food
in oven. Close door.
• READY displays. Fan and
light will turn on.
2. Press X2 key.
• Amount of time added is a
percentage of the original
preprogrammed cooking time.
• The percentage can be
changed. See Programming
the Oven Control section in
this manual.
3. Press desired preprogrammed
key or key sequence.
4. Oven begins cooking.
Displayed cooking time is the
total of original cooking time
plus the added X2 time.
Interrupting
Operation
Open oven door or press STOP/
RESET key to interrupt operation.
Display continues to show
countdown time. Close door and
press START key to resume oven
operation.