ACP DEC18E2 Quick Start Guide - Manual (Page 2)

 2011 ACP, Inc.
Cedar Rapids, Iowa 52404
Part No.12834405
Printed in U.S.A. 1/11
F
or full product documentation visit:
www.acpsolutions.com
Quick Start Reference Guide
Refer to Product Safety Manual for Safety Statements
Complete Owner’s Manual available online
Can I change an option?
Options such as single or double pad programming, beep volume,
and maximum cooking time can be changed to suit individual
preferences.
To change options:
1. Open oven door.
• If door is closed or STOP/RESET pad is pressed before programming is
complete, changes are discarded and microwave exits programming mode.
2. Press and hold pad 2 for approximately 5 seconds.
• This begins options mode.
• Microwave will beep and OPTIONS: displays.
3. Press number pad that controls option to be changed.
• See table below for options.
• Current option will display.
4. Press number pad again to change the option.
• Each time pad is pressed, option will change.
• Match code displayed with code for desired option.
5. Press START pad to save changes.
• To change additional options, repeat steps 3 and 4.
• Changes appear after door is closed or STOP/RESET pad is
pressed.
No metal pans
DO NOT power spray
Numbered Pads Display Options (Factory Settings in Bold)
1
End of Cycle Beep
OP:10
OP:11
OP:12 3 second continuous beep.
Continuous beep until door is opened.
5 beeps bursts until door is opened.
2
Speaker Volume
OP:20
OP:21
OP:22
OP:23 Eliminates beep.
Sets volume to low.
Sets volume to medium.
Sets volume to high.
3
Key Beep
OP:30
OP:31 Prevents beep when pad is pressed.
Allows beep when pad is pressed.
4
Keyboard Enable
Window
OP:40
OP:41
OP:42
OP:43 15 seconds after oven door is opened, keyboard disabled.
30 seconds after oven door is opened, keyboard disabled.
1 minute after oven door is opened, keyboard disabled.
2 minutes after oven door is opened, keyboard disabled.
5
Add Time During
Heating
OP:50
OP:51 Prevents adding heating time while oven is heating.
Allows heating time to be changed while oven is heating when a memory pad
is pressed.
6
Reset Door Open
OP:60
OP:61
Allows oven to resume heating time countdown after door is opened during
cycle.
Cancels heating time count down after door is opened during cycle.
7
Maximum Heating Time
OP:70
OP:71 Allows 60 minutes of heating time.
Allows 10 minutes of heating time.
8
Manual Operation
OP:80
OP:81 Allows use of preprogrammed pads only.
Allows use of manual time entry and preprogrammed pads.
9
Double Digit Operation
OP:90
OP:91 Allows 10 (0-9) preprogrammed pads.
Allows 100 (00-99) preprogrammed pads.
0
Clean Filter Message
OP:00
OP:01
OP:02
OP:03 Do not display message.
Display message for 24 hours every 7 days.
Display message for 24 hours every 30 days.
Display message for 24 hours every 90 days.