ACP RMS10TS Owner's Manual - Manual (Page 6)

6
Electronic Control Operation
The switching operation of this microwave oven can cause voltage fluctuations on the supply line. The operation of this oven under unfavorable voltage
supply conditions can have adverse effects. This device is intended for the connection to a power supply system with a maximum permissible system
impedance Zmax of
0.2 Ohms at the interface point of the user’s supply. The user has to ensure that this device is connected only to a power
supply system which fulfills the requirement above. If necessary, the user can ask the public power supply company for the system impedance at
the interface point.
So...how do I use it?
(2)
(3)
(4)
(5)
(6)
(7)
(2) Power Level Keys
(3) Time Entry Key
(4) Stop/Cancel Key
(5) Start Key
(6) X2 Key
(7) Number Keys
(1)
(1) LED Display
1. Power Up
“-- -- ” displays when the oven is powered up for the first
time. If
key is pressed, the oven will change to Idle
Mode.
Note: In Idle mode, no key can be pressed.
2. Idle Mode
1)The oven will enter Idle Mode after a set number
of seconds have expired in Ready Mode without a
keypad pressed or without the door being opened and
closed. The default number of seconds is 60 and maybe
changed by resetting User Option 4.
2) During Idle Mode, LED is blank. There will be no oven
activity.
3) Open and close the oven door to exit the Idle Mode
and go into Ready Mode.
3. Ready Mode
1) In this mode, the oven is ready to either begin a
manual or preset cook cycle.
2) Opening and closing the door while the oven is in Idle
Mode will put the oven into Ready Mode.
3) During Ready Mode LED displays “0:00”.
4. Door Open Mode
1) While the door of the oven is open, the oven will
be in Door Open Mode. This allows for entry into
Programming Mode.
2) During this mode, LED is blank, the fan operates and
oven light is on.
3) When the door is opened and closed, if User Option
OP:60 is selected and the oven was running a manual or
preset cook cycle, the oven will enter Pause Mode.
If User Option OP:61 is selected and the oven was
running a manual or preset cooking cycle, opening
and closing the door will clear all preset cook cycle
information.