ACP RFS518TS Quick Start Guide - Manual (Page 2)

 2010 ACP , Inc.
Cedar Rapids, Iowa 52404
Part No.12804405
Revised 6/10
F
or full product documentation visit:
www.acpsolutions.com
Quick Start Reference Guide
Refer to Product Safety Manual for Safety Statements
Complete Owner’s Manual available online
Can I change an option?
Options such as single or double pad programming, beep volume, and
maximum cooking time can be changed to suit individual preferences.
To change options:
1. Open oven door.
• If door is closed or RESET pad is pressed before programming is complete,
changes are discarded and microwave exits programming mode.
2. Press and hold pad 2 for approximately 5 seconds.
• This begins options mode.
• Microwave will beep and 0P: displays.
3. Press number pad that controls option to be changed.
• See table below for options.
• Current option will display.
4. Press number pad again to change the option.
• Each time pad is pressed, option will change.
• Match code displayed with code for desired option.
5. Press START pad to save changes.
• To change additional options, repeat steps 3 and 4.
• Changes appear after door is closed or STOP/RESET pad is pressed.
No metal pans
DO NOT power spray
Numbered Pads Display Options (Factory Settings in Bold)
1
End of Cycle Beep
OP:10
OP:11
OP:12 3 second beep.
Continuous beep until door is opened.
5 beep bursts until door is opened.
2
Key Beep Volume
OP:20
OP:21
OP:22
OP:23 Eliminates beep.
Sets volume to low.
Sets volume to medium.
Sets volume to high.
3
Key Beep
OP:30
OP:31 Prevents beep when pad is pressed.
Allows beep when pad is pressed.
4
Active Display
OP:40
OP:41
OP:42
OP:43 15 seconds after oven door is opened, keyboard disabled.
30 seconds after oven door is opened, keyboard disabled.
1 minute after oven door is opened, keyboard disabled.
2 minutes after oven door is opened, keyboard disabled.
5
On-the Fly Cooking
OP:50
OP:51 Prevents different pre-programmed pads to be activated during cooking.
6
Reset to Ready Mode
OP:60
OP:61
Opening oven door does not reset oven back to ready mode.
7
(some models)
Maximum Heating Time
OP:70
OP:71
Allows 60 minutes of heating time (some models).
Allows 10 minutes of heating time.
8
Manual Operation
OP:80
OP:81 Allows use of preprogrammed pads only.
Allows use of manual time entry and preprogrammed pads.
9
(some models)
Double Digit Operation
OP:90
OP:91
Allows 10 (0-9) preprogrammed pads.
Allows 100 (00-99) preprogrammed pads.
0
Clean Filter Message
OP:00
OP:01
OP:02
OP:03 Do not display message.
Display message for 24 hours every 7 days.
Display message for 24 hours every 30 days.
Display message for 24 hours every 90 days.
Allows different pre-programmed pads to be activated during cooking.
Opening oven door resets oven back to ready mode.