VANCO VPW-280754 - Manual (Page 15)

www.vanco1.com
888.769.4156 15
EDID DIP Switch settings
Distribution of HD signals through the matrix requires mutual communication or ‘handshake’ between source
and display. If there is any disparity between the two, successful transmission becomes problematic.
This matrix comes equipped with an EDID DIP switch for manual adjustment of matrix settings to encourage
communication between INPUT and OUTPUT devices. If installation compatibility issues arise, check the
settings on your connected devices and adjust the DIP settings as required.
ATTENTION Changes to the DIP switch settings should be made with the matrix OFF, ideally with all power
cables and HDMI leads and UTP cables removed to guard against electrostatic build up that may damage your
system. DO NOT HOTSWAP your cables when changing DIP SETTINGS.
ALL changes to the DIP settings become effective upon powering ON the matrix.
EDID Copy from Output display to Input port (Force Signal Output mode)
AVR 7.1 Audio EDID COPY to Blu-ray source (AV Receiver copy)
For users who wish to copy EDID from an AV Receiver with 7.1 channel audio to a specific input port
containing a Blu-ray player, follow a variation on the instructions above:
1 Set the DIP switch to the above position with the matrix in the OFF position.
2 Connect the AVR to your desired OUTPUT port on the matrix (for example, OUTPUT 2)
3 Power ON the matrix and select your INPUT your chosen SOURCE is connected to (for example, INPUT 3 –
Blu-ray)
4 Press and hold the OUTPUT SELECT button for 3 seconds for the EDID data to be copied from OUTPUT 2
(AVR) to INPUT 3 (Blu-ray).
1080p 3D Video / Stereo Audio