Rough Country PERF689 - Manual (Page 6)

18. Install the side plates with the supplied 10mm x 35mm bolts as shown. Snug but do not fully tighten at this time See
Photo 11.
19. Center punch and drill using a 17/32 drill bit. See Photo 12.
20. Remove the side plates and drill the rear hole only using a 25/32” drill bit. See Photo 13.
21. Install the crush sleeves in the frame. See Photo 14.
22. Reinstall the side plates with the supplied 1/2” x 4 1/2” bolts and nuts in the rear holes using a 3/4” wrench. See
Photo 15.
23. Secure using the supplied 1/2” x 1 1/2” bolt and flag nut in the front holes of the side plates. See Photo 16. Tighten
using a 3/4” socket.
PHOTO 11 PHOTO 12
PHOTO 13 PHOTO 14
PHOTO 15 PHOTO 16
Rear
Rear
Install the side plates Drill using a 17/32” drill bit
Drill rear hole only using a 25/32” drill bit Insert crush sleeve in frame rail
Secure with supplied hardware Place flag nut in frame