Bestop Windshield Channel for Jeep JK Wrangler and Wrangler Unlimited (Part Number 51243) - Manual (Page 2)

Header Windshield Channel Installation Instructions
Rev. D 0109 51243 pg. 2
Parts List and
Hardware Identifi cation
Windshield Header,
Part Number 423.45,
Qty - 1
#10-24 Locknut, Part
Number 195.93, Qty - 8 #10-24 x 3/8" Phillips Truss
Head Screw, Part Number
195.92, Qty - 8
Header Knob Base -
Right, Part Number
445.08, Qty - 1 Header Knob Base -
Left, Part Number
445.09, Qty - 1
Header Knob Plate, Part
Number 445.10, Qty - 2
Header Knob, Part
Number 440.55, Qty - 2
The bottom of each Header Knob Base
is stamped with an R for right or an L for
left.
Place the Right Header Knob Base
over the four holes with the tab of the
base pointing to the front of the Header.
Secure the Header Knob Base to the
Header with four (4) #10-24 x 3/8" Phil-
lips Truss Head Screws and four (4)
#10-24 Locknuts.
Repeat this procedure with the left base.
Install Header Knob Bases
on Header
Header
Header Knob
Bases
#10-24 x 3/8"
Phillips Truss
Head Screws
and #10-24
Locknuts
Slide the pocket sewn along the front of the Bikini
over the edge of the header and snap it to the
snaps.
Snap Bikini to Header
Snap Fabric
to Header